Easy Way Wholesale
Concrete Clean & Etch
 

Cleans & etches in one step.

  • Cleans & Prepares Concrete, Masonry & Brick for Coating, Staining or Sealing.
  • Ideal for cleaning, degreasing, and acid etching concrete floors, walls, basements, driveways, swimming pools, patios, and containment areas prior to coating, staining or sealing.
  • Safer and easier to use that muriatic acid, it creates a porous surface, and provides the even profile and uniform appearance preferred for clear coating applications. Also removes efflorescence (alkali salts) and neutralizes new concrete and new mortar joints or cinder block, masonry and brick.

Earth Friendly:

Water-Based . Biodegradable . Ordorless . Non-Flammable . Environmentally Responsible

Recommended Uses:

Concrete Clean & Etch is ideal for cleaning, degreasing, and acid etching concrete floors, walls, basements, driveways, swimming pools, patios, and containment areas prior to coating, staining or sealing. Safer and easier to use than muriatic acid, it creates a porous surface, and provides the even profile and uniform appearance preferred for clear coating applications. It can also be used to remove efflorescence (alkali salts) and to neutralize new concrete and new mortar joints on cinder block, masonry, and brick.

Directions for Wet Surfaces:

  1. Mix 1/3 gallon (1.27 liter) of concentrate with 3.79 liter (one gallon) of water in a plastic sprinkling can. One gallon (3.79 liter) of concentrate will produce 4 gallon (15.14 liter) of premix; sufficient to cover 800 square feet. Hot water will accelerate cleaning and etching.
  2. Sweep the surface to remove loose debris, and scrape off excess grease and oil.
  3. Cleaning a 10’ x 10’ section at a time, dampen the surface with a fine spray of water, and using the sprinkling can, apply the premix evenly over the surface.
  4. Scrub the premix into the surface with a stiff bristled broom until the foaming stops. NOTE: If no foaming occurs, surface has been previously sealed and this will prevent penetration of premix. Remove the sealer and reapply KRUD KUTTER CONCRETE CLEAN & ETCH premix.
  5. Triple rinse the surface with a water hose. Scrub while rinsing to ensure removal of all loosened material.
  6. Allow the surface to dry thoroughly before applying stain or sealant.
  7. After the surface has dried, check any glossy or oily areas by applying a few drops of water. If water does not penetrate quickly, re-etch the affected areas.

Color: Red

Available In:

946 ml 3.79 ltr
 

Home | Products | Solutions | Shopping | Disclaimer | Company | Contact
© 2011 EasyWay. All rights reserved | Weboptimizers